5 thoughts on “How to process the acrylic board”

  1. Shirley

    Puning to the acrylic panel is a very common process, but many customers report that the panel burst occurs when the acrylic panel is poured. So how should the burst happen? The more briefly summarized the infrared sea for your reference. Therefore, when perforation of the acrylic board, pay attention to leave a gap for the telescopic and shrinkage of the acrylic panel, and beat the holes; there is also a burst when the screw is twisted too tightly; Don't be too close to the edge.
    2. Use ordinary twist drills to grind into three -pointed shape. The tip of the middle is slightly higher. Such a drill can drill organic glass. Or shake the drill with your hands. Drill it evenly, and the pores left under the glass plate should be small to enhance the strength of the glass. You can also put some sand on the glass to enhance friction.
    3, the punching position cannot be scrubbed with alcohol, otherwise it will easily burst.
    The more high -quality acrylic organic glass plates are used to avoid bursting from bursting.

  2. Ashley

    The acrylic board has good processing performance, which can not only use heat molding (including mold pressure, blowing plastic and vacuum -sucking), as well as any drill, car, cutting, etc. The mechanical cutting and sculpture controlled by microcomputer not only greatly improves the processing accuracy, but also can also produce patterns and shapes that cannot be completed in traditional methods. In addition, acrylic boards can use laser cutting and laser carvings to make strange products.

  4. Sara

    The original poster still uses the knife steel ruler. Line, but it ’s not true. The accuracy and fineness and the poor efficacy laser is basically the method of all stores.

Leave a Comment